Instructions on how to replace car glass washer water tank sensor

Instructions on how to replace car glass washer water tank sensor

The phenomenon of a faulty glass cleaner on the dashboard that does not perform glass washing is mainly due to a damaged water tank sensor. You should test it out and replace it quickly.

1. Prepare tools

– Repair kits.
– Windshield washer fluid.
– Water tank sensor.

2. Steps to be taken

Step 1: First stop the car and turn off the engine, open the front cap to find the location of the glass washer, usually on the left end of the car, then fill the tank with glass cleaner.

Step 2: Remove the water tank sensor.

  • Remove the cover from the bottom of the car front to find the radiator and the sensor.

  • Located at the bottom of the glass washer is a sensor, attached to the power cord to the control panel to receive commands and refill the windshield with water. Use a flattened head screwdriver to separate and remove the sensor from the radiator.

  • Note when removing the sensor from the water tank, the water in the tank will follow this open bottom position and drain the water out. Use a can or sink to catch the glass wash in the safe until all the water is drained.

Step 3: Check and replace tank sensor.

  • Once the sensor is removed from the radiator you can use a multimeter to determine if the sensor is damaged.

  • Once you’ve identified a damaged sensor, replace it for the glass washer unit, and then reassemble the vehicle.

Step 4: Finally, fully refill the glass cleaner in the car wash tank and then check the error message on the dashboard to see if it is effective in fixing the error.

Related post:  Effects of sudden increase or decrease in car throttle when driving

Source link < Instructions on how to replace car glass washer water tank sensor > Automotivesta.com

Be the first to comment

Leave a Reply

Your email address will not be published.


*