Common damage to automotive cooling and lubricating systems

Common damage to automotive cooling and lubricating systems

The cooling system and the lubrication system are two important parts that help the car to operate smoothly and smoothly. However, these two parts also have many failures that you need to know for early detection and repair.

1. Oil pressure is lower than standard

When this phenomenon occurs, the vehicle owner needs to check the oil pump, because the oil pump may be damaged. In addition, the oil pump’s stabilizer valve may be damaged. Next are the details of the plunger group – the rod is worn out, or the oil is detected. It is also possible that due to the failure of the lubricating oil pressure gauge, the reduced lubricant viscosity causes the car to fail.

2. The oil level at the bottom of the engine vehicle is not in accordance with the regulations

If you check that the oil level at the bottom of the engine is not correct, it means that the oil level is decreased or increased. Oil can also be consumed a lot in the air compressor, so check the relevant parts for best remedy when the oil level at the bottom of the engine cartridges is not correct.

3. Poor quality of oil in engines

In addition, if you find that the oil quality in the engine is poor, it is possible that the oil is diluted, the oil is dirty, the oil filter is dirty or the owner of the engine oil changes on time. If this situation occurs without remedial measures, the parts in the engine will be worn out, leading to engine failure.

Related post:  See details

4. Leaked cooling system

When the car goes quickly, the engine is hot, and if the cooling system is leaked, immediately check the hoses because they may be damaged. Next is the water pump seal is damaged, the water pump shaft seal is damaged, which also causes the leak of the cooling system, causing the car to heat up quickly, and there is a high risk of fire and explosion.

5. Engine cooling is not good

Poor engine cooling can be caused by broken water pump blades, damaged oil radiators, and broken wind blades. Or it is possible that the water in the cooling system is exhausted, with these errors that need to be meticulously checked by technicians to fix.

6. The water in the cooling water tank overflows

If this occurs, the lid gasket with the body is damaged, the lid is not tight, or the cooling system radiator may be blocked. Also, due to cracks in the engine cylinder.

Source link < Common damage to automotive cooling and lubricating systems > Automotivesta.com

Be the first to comment

Leave a Reply

Your email address will not be published.


*